Section 4-Configuration Mode; Introduction - Garmin G1000 Maintenance Manual

_________________________________________________________________
This section provides an overview of the configuration mode of operation. This section presumes basic
familiarity with the basic operation of the G1000.
To more closely match the LRU nomenclature displayed on the configuration pages,
and where appropriate, only the prefix of the LRU will be listed in this section and in
the rest of the manual (i.e., GTX 33(x); GTX, etc.). The only duplicate in the prefix of
any LRU pertains to the GDL 69(x) XM Satellite Receiver and the GDL 90 GPS
WAAS receiver/UAT. The suffix will be added in that situation.

4.1 INTRODUCTION

Screen displays shown in this section are not aircraft or system software level specific.
Consult airframe specific guides and manuals for the most current screen display
information.
Configuring, calibrating, and troubleshooting the G1000 can be performed when the G1000 is in
configuration mode.
To enter configuration mode:
1. Press and hold the ENT key on the PFD while applying power. Release the ENT key after
'INITIALIZING SYSTEM' is displayed in the upper left corner of the PFD.
2. Repeat step 1 for the MFD. The System Status Page (Figure 4-1) is displayed on the MFD and the
PFD.
G1000 System Maintenance Manual
190-00907-00
SECTION 4
CONFIGURATION MODE
Figure 4-1. System Status Page (Configuration Mode)
NOTE
NOTE
Page 4-1
Rev. B