Using A Headset; Answering System Operation; Selecting The Outgoing Message; Recording/Deleting An Outgoing Message - Radio Shack TAD-3806 Owner's Manual

43-3806.fm Page 17 Tuesday, August 8, 2000 11:29 AM

USING A HEADSET

You can talk with hands-free convenience
using an optional headset that has a
(2.5-mm) plug. Contact your local Ra-
dioShack store for a suitable headset.
To connect the headset, open the rubber
cover on the side of the handset, then insert
the headset's plug into the jack.
Notes:
• Connecting a headset disconnects the
handset's earpiece and microphone.
ˆ

Answering System Operation

SELECTING THE
OUTGOING MESSAGE
The answering system has two prerecorded
outgoing messages. One asks the caller to
leave a message: "Hello, no one is available
to take your call. Please leave a message af-
ter the tone." The system uses this message
when is set to
REC TIME
the Record Time" on Page 18). The other is
simply an announcement and does not let
the caller leave a message: "Hello, no one is
available to take your call." The system uses
this message when
REC TIME
(announcement only).
You can also record your own message (see

"Recording/Deleting an Outgoing Message").

When you record your own outgoing mes-
3
/ -inch
32
With a headset connected, you make or an-
swer calls as usual using the keys on the
handset. You can also answer calls by
pressing
You can use an optional handset holder
(available from your local RadioShack store)
to hang the handset on your belt for greater
convenience.
When you finish using the headset, discon-
nect it from the handset and close the rubber
cover to protect the jack.
sage, the system uses it for all
tings.
To switch between your outgoing message
and the system's prerecorded message,
press
gins to play, press
switches to the other message and plays it.
or (see "Setting
1 4
RECORDING/DELETING AN
OUTGOING MESSAGE
To record your outgoing message (up to 30
is set to seconds long), hold down
ANN
tem beeps and
your message, press
OGM
Answering System Operation
• on the handset also controls
VOLUME
the connected headset's volume.
• If you place the handset on the base to
recharge it while the headset is con-
nected, be sure the handset seats prop-
erly.
.
SPEAKER
. When the current message be-
OGM
again. The system
OGM
OGM
– – appears. When you finish
PLAY/STOP J J J J
. The system plays back your message.
set-
REC TIME
until the sys-
7 7 7 7
or
17