Removing And Installing The Front Grille; How To Set The Different Addresses - Daikin FTX09NMVJU Installation Manual

2�

Removing and installing the front grille

• Removal method
1) Remove the front panel to remove the air fi lter.
2) Remove the 2 screws from the front grille.
(The 18 and 24-class models have 3 screws.)
3) In front of the
Lightly pull the front grille toward you with one hand, and push down
on the hooks with the fi ngers of your other hand.
When there is insuffi cient work space because the unit is close to ceiling
CAUTION
• Be sure to wear protection gloves.
Place both hands under the center of the front grille, and while pushing
up, pull it toward you.
• Installation method
1) Install the front grille and fi rmly engage the upper hooks (3 locations).
2) Install 2 screws of the front grille.
(The 18 and 24-class models have 3 screws.)
3) Install the air fi lter and then mount the front panel.
3�

How to set the different addresses

When 2 indoor units are installed in one room, the 2 wireless remote
controllers can be set for different addresses. Change the address setting
of one of the two units. When cutting the jumper be careful not to damage
any of the surrounding parts.
1) Remove the battery cover on the remote controller and cut the address
jumper.
2) Press ,
3) Press , then select , press
(The indoor unit OPERATION lamp will blink for about 1 minute.)
4) Press the indoor unit ON/OFF switch while the OPERATION lamp is
blinking.
• If setting could not be carried out completely while the OPERATION
lamp was blinking, carry out the setting process once again from the
beginning.
• After setting is complete, pressing
the remote controller to return to the previous display.
11
mark on the front grille, there are 3 upper hooks.
and at the same time.
.
for about 5 seconds will cause
 mark area
(3 locations)
Upper hook
2) Pull toward you.
Jumper
Jumper ADDRESS
EXIST 1
CUT 2
ON/OFF
Upper hook
Push
down.
1) Push up.
OPERATION
lamp
Indoor unit
ON/OFF
switch
■
English