Service Notes - REVELL 23970 Manual

with adhesive tape in order to prevent short-circuiting! Maintenance and care: Please only use a
clean, damp cloth to wipe off the model./Protect the model and batteries from direct sunlight and/or
direct heat. /Never allow the model, the remote control and charging unit to come into contact with
water. This may result in its electronics becoming damaged./Transformers, power supplies or battery
chargers used with the model are to be regularly examined for damage to the cord, plug, enclosure
and other parts, and in the event of such damage, they must not be used until the damage has been
repaired. Required batteries for the multicopter: Power supply:
Wh/Batteries: 1 x 3.7 V rechargeable LiPo battery (interchangeable)/Capacity: 100 mAh/Battery
requirement for the re mote control: Power supply:
USB charging unit: Power supply:
Safety instructions for charging the Multicopter:
Attention: The battery and motor must cool down for 10 to 15 minutes before charging and after
every flight. Otherwise they can be damaged. The charging process must be constantly monitored.
Always ensure that the charging process takes place on a fireproof surface in a fire-resistant environment./
Switch off the helicopter and the remote control./Plug the charging unit into an unoccupied USB port
and then connect the multicopter to the charging unit. The charging unit illuminates./The charging
process lasts approx. 35 minutes and must be continuously monitored. The light on the charging unit
goes out when the charging process is finished./Disconnect the multicopter from the charging unit
and disconnect the charging unit from the USB port after the charging is completed.The multicopter
can fly for approx. 4-5 minutes after a charge time of approx. 35 minutes./Warning notice:
The LiPo battery can become warmer during charging. If it should become hot and/or changes to the
surface begin to appear, immediately discontinue the charging process!
General flying tips:
Always place the multicopter on a level surface. An inclined surface can, under certain circumstances,
have a negative impact on the starting behaviour of the multicopter./Always move the controls slowly
and with a gentle touch./Always maintain visual contact with the multicopter and do not look at
the remote control!/Move the thrust control down again somewhat as soon as the multicopter lifts
off from the ground. To maintain the flying altitude, adapt the setting of the thrust control./If the
multi copter lowers, move the thrust control slightly upward again./If the multicopter climbs, move
the thrust control down slightly./In order to fly along a curve, it often suffices to tap the directional
control very slightly in the respective direction. On initial flight attempts, there is a general tendency
toward excessive movements of the multicopter controls.Always move the controls slowly and care-
fully. Never fast and fitfully./Beginners should only attempt to master the thrust control after the trim
adjustment. The multicopter does not necessarily have to fly straight at the beginning - initially, it
is more important to maintain a constant height of approximately one metre above the ground by
repeatedly tapping the thrust control. Only then should the pilot practice steering the multicopter left
and right.
The suitable flying environment:
The location in which the multicopter is flown should fulfil the following criteria: It should be an indoor
location with still air. Insofar as possible, there should be no air condition systems, heaters, etc., which
could cause airflow./The room should be at least 10 metres long, six metres wide and three metres
high. For stunt flying, we recommend flying outdoors or in a large hall with at least 10 min each
direction./There should be no disruptive objects in the room (fans, lamps, etc.)./When starting, make
absolutely sure that all persons and animals - including the pilot - are at least 1-2 metres away from
the aircraft before the flight begins.
Attention!
Liability insurance has been mandatory since 2005 for flying model aircraft and helicopters outdoors.
Contact your private liability insurer and make sure that your new and earlier models are included in
the insurance coverage. Request confirmation in writing and keep it in a safe place. Alternatively, the
DMFV offers a trial membership free of charge online at www.dmfv.aero, which includes insurance.
You can find our telephone, ordering options and replacement tips for spare parts, as well as
additional useful information about all models from Revell Control.
/DC 3 V/Batteries: 2 x 1.5 V "AAA" (not included)/
/Rated output: 5 V / 500 mA

SERVICE NOTES

/Rated output: DC 3.7 V / 0.37