Type Of Measurement; Taking Measurements; Data Acquisition - Jeulin Initio 2 Manual

Measurement
®
Ventilation Initio 2
Ref : 453 146
2.2 Browsing
Initio
Selection-confirmation (3):
The central knurled knob (3) is to scroll through the menus of the Initio
the OK button in the center of the knurled knob confirms the selection.
Back (2):
The "Back" button (2) is used to switch from one type of display to another from the main
screen in the following order:
Within a menu it is used to go back a step.
Menu (4):
This button displays Initio

2.3 Type of measurement

The Initio
Using the knurled knob, select the measurement name in the top left.
Press the knob to change the type of measurement:
V -> Volume
F -> Flow rate
RR -> Respiratory rate
For the volume and flow rate, two sizes are available:
Volume 10L
Flow rate 5 L/s
To change the size, using the knurled knob, select the calibre located to the right of the size
name.
Press the knob to change the calibre size:

2.4 Taking measurements

To take an accurate measurement, place the probe near the mouth (about 10 cm away), with
the cable outwards and press the transparent button with your thumb. Wait until the flashing
stops to begin the measurement.
This operation allows resetting the measurement (for the volume) and to calibrate the probe.

2.5 Data acquisition

Initio
available:
ENGLISH
®
2 has three navigation buttons:
- Measurement
- Table
- Curve
® 2's main menu.
®
2 Ventilation takes 3 types of measurements:
- The volume of air
- The air flow rate
- The respiratory rate
- Measurement choice
- Choice of caliber
100L
10 L/s
®
2 has an internal memory that enables it to save measurements. Two modes are
9
®
2. Briefly pressing