Table of Contents
Advertisement
Regulation of the draft
Button turns with extra accessories and has two extreme positions:
Right cooker stove
cooker stove Picture 10
Close
Picture 11
NOTE: If the primary air regulator is open, the air flow is steady, so that can lead
to the overheat the water in the system.
Close
Open Picture 12
Picture 9
1. Turning to the final position in the direction shown in
picture.10. gives a maximum draft;
direction shown in picture.10, gives a minimum draft;
Left
closed position and it should be kept in this position at
all times of work of the stove. When closed, the
regulator prevents air intake from the front side below
the the grille, which automatically regulates the intensity
of burning by draft regulator, located on the back side
of the stove. If for some reason burning is difficult, due
Close
to weather conditions or high humidity fuels (wood,
coal),
open(Picture.11).
Regulation of the secondary air
The secondary air regulator should be put in
the position closed during ignition and
position until you establish the operation heating regime.
After that,
hold it in that position during the stove is in operation. The
secondary air is used to clean
Combustion rate and thus the amount of heat
which gives the stove, depends on the amount of
combustion air that is brought into the space
below grill. Regulation of the amount of air is
achieved automatically through the controller of
draft Rathgeber placed on the back of the stove
(Picture 9), or manually, by turning of the button on
the stove frame connected with the draft regulator
(Picture 1 position 28).
2.
Turning to the end position opposite of the
Primary air regulator (position.20) is set in the
the
controller
put theregulator into the position opened and
of
the
primary
held in that
air
can
Advertisement
Table of Contents
