Part Numbers - Cisco RF Gateway 10 Quick Start Manual

The T-10 TORX driver tool and a 1/4-inch flathead screwdriver are used to remove and install the cable bar clamp on the UCH,
and loosen the line card captive screws.
The Cisco RFGW-10 UEQAM coaxial cable interface uses 75-ohm precision miniature video cable bundled cables terminated
to 75-ohm MCX connectors. The cables come in bundles of five that will fit into the provided rear RF cable management
bracket.
The Cisco RFGW-10 UEQAM coaxial termination must use quad-shielded 75-ohm precision miniature video cable.
Note
Note Other bundle types exist for quad-shielded 75-ohm precision miniature video cable but only the five bundle will fit into
the provided cable management bracket and allow for easy removal of the RF Switch Cards.
Figure 15 5-Bundle Quad-Shielded Cable with MCX Connectors
MCX
connectors
F connectors
Caution The Cisco RFGW-10 UEQAM must be used with the provided UCH for all cable connections to the RF Switch
Card. Failure to use the UCH may cause permanent damage to the line card connectors, resulting in low or no RF
output in the downstream or low or no RF input in the upstream.
The cable used with the dense connector UCH must be 75-ohm precision miniature video cable.
Note

Part Numbers

Table 3 lists the part numbers for the Cisco RFGW-10 UEQAM RF Switch cards, cable kits, cables, connectors, tubing, and
tools.
Table 3 Part Numbers
21