GE Criterion GEH-5874 Instructions page 2

WIRING
Make all electrical connections in accordance with
all applicable code requirements (National Electrical
Code, Canadian Electrical Code and applicable local
codes).
This luminaire is equipped with a SnapDrive™ electrical
system. The SnapDrive is equipped with a multi-volt ballast.
Ballast has been wired to the voltage indicated on the
nameplate. If another voltage is desired, place the voltage
selection jumper onto the appropriate voltage position as
indicated on the wiring diagram on the Snapdrive ballast
cover. Optional features such as fusing and photocontrols
are voltage specific. Do not change jumper positions if
fixture is equipped with these features. This will damage
or destroy these optional parts and will void the applicable
safety listing (UL, CUL, CSA, etc.) of the fixture.
SNAPDRIVE REMOVAL AND INSTALLATION
To remove Snapdrive: with the power off, open door by
releasing the two top latches. Disconnect all wire harnesses
from SnapDrive. Press clip located at bottom end of module
(see figure 3). Swing Snapdrive forward and lift off the
hooks located at top end Snap Drive . (See figure 4).
To install Snapdrive: with power off, open door of unit,
Hang module on hooks (figure 3). Swing Snapdrive into
clip lifting slightly as Snapdrive is swung into place. An
audible snap should be heard which indicates the module
has seated. Replace wiring harnesses into proper
receptacles.
Figure 3
Figure 4
LAMP INSTALLATION
Use only lamps specified on nameplate. Observe
lamp manufacturer's recommendations and
restrictions on lamp operation, particularly ballast
type, burning position, etc.
Lamp Tightness-Medium Base Lamp: The lamp should
be tightened to a light firmness sufficient to depress the
center contact.
MAINTENANCE AND CLEANING
It will occasionally be necessary to clean the outside of
the door glass to maintain light levels. Frequency of
cleaning will depend on ambient dirt level and minimum
light level that is acceptable to the user. The door glass
should be washed in a solution of warm water and any
mild, nonabrasive household detergent, rinsed with clean
water and wiped dry. Should the optical assembly become
dirty on the inside, wipe the reflector and clean the
refractor in the above manner.
Hooks
The light output of a luminaire is dependent on the age
of the lamp. In applications where the light level is critical,
it may be desirable to replace lamps before they burn out.
SnapDrive
The lamp manufacturer can provide data showing how the
Electrical System
lamp light output decreases with use.
Clip
CAUTION
Risk of burn
• Allow lamp/fixture to cool before
handling
WARNING
Risk of burn
• Do not touch operating luminaire