Advertisement
Forum | Frame Series | Suspended Mounting
Installation
1
Mount remote driver box to structure within 50' from fixture. Run
positive wire to first junction box and negative wire to second junction
box to make conductive cable connection. If fixture is hung by conical
cables bring both positive and negatives wires to the same junction
box.
2
Turn off the power to the fixture's circuit. With the fixture
supported in the air, raise the cable assemblies to their
corresponding junction boxes, thread the conductive cable (A)
through the canopy (B), cross bar (C), and respective components
(D). Apply heat shrink (E) to the exposed conductive cable and
connect the power feed from the ceiling side to the conductive cable
via quick connect (F).
Install the junction box cross bar, slide canopy up into place and
thread on remaining hardware to hold the canopy in place. Follow
governing electrical code for making your connections in the
junction box.
F
E
C
B
D
A
3
With fixture now mounted, you can slowly lower it into place. Fine
adjustments to height and leveling can be made at the
gripper assemblies located on the upper surface of the fixture.
COMPONENTS FOR SUSPENDED MOUNTING
The Frame series cable mounting system consists of two main
components: the power feed assemblies (A) and the remote mount
driver box (B). Both items come shipped with the fixture to help ensure
proper counts and clarification during assembly.
In preparation of installation, ensure that crossbars, canopy covers,
cable grippers and cord grips are all accounted for. The cable mounting
system utilizes conductive suspension cables to be used with a standard
j-box for each cable. Be sure to follow all governing code related to
wiring, structural integrity, and use of materials.
A
B
3
Installation Guide
A
Advertisement
