Advertisement
ELECTRIC HAMMER / BORMASINA ELECTRO-PNEUMATICA
ACCESSORIES CONTENTS:
3 X 150 MM SDS DRILLS (Ф8, 10, 12 MM)
1 X 250 MM SDS POINTED CHISEL (Ф14 MM)
1 X DEPTH GAUGE
THE PICTURES BELOW INTEND TO MAKE YOU FAMILIAR WITH DIFFERENT FUNCTIONS OF YOUR ROTARY
HAMMER. THESE PICTURES MAY NOT SHOW THE ACTUAL ROTARY HAMMER MODEL THAT YOU HAVE
PURCHASED. BEFORE ANY INTERVENTION, YOUR ROTARY HAMMER MUST BE DISCONNECTED FROM THE
POWER SOURCE.
OPERATING YOUR ROTARY HAMMER
1.
FITTING THE AUXILIARY HANDLE
ATTACH THE HANDLE AS SHOWN IN PICTURE 1
DEPENDING ON BEING LEFT HANDED OR RIGHT
HANDED.
TIGHTEN
LOOSEN
PICTURE 1
2.
FITTING SDS DRILL OR OTHER ACCESSORIES
THE HAMMER IS EQUIPPED WITH A SDS CHUCK
SYSTEM. GRIP AND PULL BACK THE LOCKING
ING SLEEVE TO INSERT A SDS DRILL OR OTHER
ACCESSORIES. PUSH THE DRILL OR OTHER
ACCESSORIES INTO THE SDS PLUS CHUCK
UNTIL A RESISTANCE IS FELT (SEE PICTURE 2). IT
MAY BE NECESSARY TO SPIN THE SDS DRILL OR
CHISEL UNTIL ITS SHAFT IS WELL PLACED IN
THE SDS PLUS CHUCK RELEASE THE LOCKING
SLEEVE TO LOCK THE SDS DRILL OR OTHER
ACCESSORIES.
Ref.647057
ROTARY HAMMER IN OPERATION
5/17
1 X DUST CAP
1 X GREASE POT
PICTURE 2
3.
REMOVING
SDS
DRILL
ACCESSORIES
REVERSE ALL THE OPERATIONS STEP BY STEP
IN POINT 2. TO REMOVE THE SDS DRILL OR
OTHER ACCESSORIES INSTALLED.
4.
SETTING THE DEPTH GAUGE
●
ROTATE THE HANDLE ANTI-CLOCKWISE,
INSERT DEPTH GAUGE INTO THE HANDLE (SEE
PICTURE 3).
● ADJUST THE DEPTH GAUGE TO THE DESIRED
DEPTH.
● ROTATE THE HAND CLOCKWISE TO TIGHTEN
THE DEPTH GAUGE.
PICTURE 3
OR
OTHER
Advertisement
