Advertisement
ELECTRIC HAMMER / BORMASINA ELECTRO-PNEUMATICA
HAVE THE POWER TOOL REPAIRED BY QUALIFIED
PEOPLE. ANY POWER TOOL THAT CANNOT BE
CONTROLLED WITH THE SWITCH IS DANGEROUS
AND MUST BE REPAIRED BY A QUALIFIED PERSON.
DISCONNECT THE POWER TOOL FROM THE POWER
SOURCE BEFORE ANY INTERVENTION. DISCONNECT
THE PLUG FROM THE POWER SOURCE AND/OR THE
BATTERY PACK BEFORE MAKING ANY ADJUSTMENT,
CHANGING ACCESSORIES, STORING THE POWER
TOOL, AND MAINTAINING THE POWER TOOL.
STORE POWER TOOLS IN A SAFE PLACE. STORE
IDLE POWER TOOLS IN A DRY AND A CLEAN PLACE,
OUT OF THE REACH OF CHILDREN.
MAIN SAFETY INSTRUCTIONS FOR ROTARY HAMMER
ALWAYS USE THE SIDE HANDLE FOR MAXIMUM
CONTROL OVER TORQUE REACTION OR KICK BACK.
OPERATE YOUR ROTARY HAMMER WITH YOUR TWO
HANDS TO ENSURE THAT YOU ARE IN A STABLE
STANDING POSITION. FOR EXAMPLE, DO NOT USE
THIS ROTARY HAMMER WHILE BEING ON A LADDER.
POSITION THE CORD CLEAR OF ROTATING DRILL. DO
NOT WRAP THE CORD AROUND YOUR ARM OR WRIST.
IF THE CORD BECOMES ENTANGLED WITH THE
SPINNING BIT IT COULD ENTRAP YOU, CAUSING
SERIOUS PERSONAL INJURY.
POSITION YOURSELF TO AVOID BEING CAUGHT
BETWEEN THE TOOL OR SIDE HANDLE AND WALLS
OR POSTS. IF THE DRILL BOUNDS OR JAMS IN THE
WORKPIECE, THE REACTION TORQUE OF THE TOOL
COULD CRUSH YOUR HAND OR LEG.
NEVER PLACE YOUR ROTARY HAMMER DOWN UNTIL
THE DRILL OR THE OTHER ACCESSORY HAS COME
TO A COMPLETE STOP.
DO NOT USE DULL OR DAMAGED DRILLS OR OTHER
ACCESSORIES. DULL OR DAMAGED DRILLS HAVE A
GREATER TENDENCY TO BIND IN THE WORKPIECE.
Ref.647057
MAINTAIN PREVENTIVELY THE POWER TOOL.
-
INSPECT REGULARLY THE MOUNTING PARTS;
CHECK IF ALL THE LOOSE SCREWS ARE
PROPERLY TIGHTENED.
-
REGREASE THE POWER TOOL WITH GEARS
WITH SPECIAL LUBRICANT AT EVERY BRUSH
CHANGE.
-
AFTER REGULAR EXAMINATION OF THE STATE
OF THE BRUSHES AND COMMUTATOR, SEE
WHETHER
THESE
CHANGED.
-
CLEAN YOUR POWER TOOLS BODY USING A
CLEANING CLOTH LIGHTLY WET WITH A MIXED
SOLUTION OF WATER AND SOAP
WHEN
REMOVING
THE
ACCESSORIES
FROM
CONTACT WITH THE SKIN AND USE PROPER
PROTECTIVE GLOVES WHEN GRASPING THE DRILL
OR ACCESSORY. ACCESSORIES MAY BE HOT AFTER
PROLONGED USE.
LUBRICATE THE GEAR BOX. THE GEAR BOX MUST BE
LUBRICATED AFTER APPROXIMATELY 5 HOURS OF
USE TO ENSURE IT WORKS EFFICIENTLY (SEE THE
GEAR GREASE BOX LOCATION ON ON PAGE 4) . A
SMALL CONTAINER OF GREASE IS SUPPLIED WITH
THE HAMMER.
3/17
PARTS
NEED
TO
BE
DRILL
OR
OTHER
THE
TOOL,
AVOID
ANY
Advertisement
