American Audio DP-2 User Manual And Reference Manual page 28

Professional digital producer
Hide thumbs Also See for DP-2:
Table of Contents

Advertisement

(25) Play/Pause Button 
Each press of the Play/Pause Button causes the operation to change from play to pause or from pause to play. While in play mode the green LED 
will glow and while in pause mode the green LED will flash. 
(26) Cue 
Pressing the Cue Button during playback immediately pauses playback and returns the track to the last set cue point. The red CUE LED will glow 
when the unit is in cue mode. The LED will also flash every time a new Cue Point is set. The Cue Button can be held down to momentarily play the 
track. When you release the Cue Button it instantly returns to the Cue Point. You can also tap the Cue Button to create a "Bop Effect". 
(27) Crossfader 
This fader is used to blend the output signals of channels A and B together. When the fader is in the full left position (channel A), the output signal 
of channel A will be controlled by the master volume level. The same fundamentals will apply for channel B. Sliding the fader from one position to 
another will vary the output signals of channels A and B respectively. When the crossfader is set in the center position, the output signals of both 
the channels A and channels B will be even. 
(28) Channel EQ Section 
Channel Treble (High) Control 
This knob is used to adjust the treble (high) levels of a channel allowing for a maximum treble gain of +10dB or maximum decrease of ‐26dB. 
Turning the knob in a counter‐clockwise direction will decrease the amount of treble applied to a channel signal, turning the knob in a clockwise 
direction will increase the amount of treble applied to a channel signal.  
Channel Bass (Low) Control 
This knob is used to adjust the bass (low) levels of a channel allowing for a maximum bass gain of +10dB or maximum signal decrease of ‐26dB. 
Turning the knob in a counter‐clockwise direction will decrease the amount of bass applied to a channel signal, turning the knob in a clockwise 
direction will increase the amount of bass applied to a channel signal. 
©American Audio® 
www.americanaudio.us           www.americanaudio.eu 
DP‐2™         User Manual Page 28 

Advertisement

Table of Contents
loading

Table of Contents