Assigning Input Signals To Connectors; For The Bvm-D14H Series Video Monitors - Sony BKM-143HS Operation Manual

Assigning Input Signals
to Connectors
After installing the BKM-143HS into your video monitor,
the menu screens will change automatically.
For the BVM-D14H series video
monitors
Use the INPUT CONFIGURATION menu for the signal
assignment.
1
After selecting a channel to assign a signal, display the
MENU screen and select the INPUT
CONFIGURATION menu.
2
Select FORMAT in the INPUT CONFIGURATION
menu.
18

Assigning Input Signals to Connectors

3
Select SDI-AUTO.
4
Select either INPUT 1 or INPUT 2 in INPUT NO of
the INPUT CONFIGURATION menu.
For details on using the menus, refer to the Operation
Manual for your video monitor.
When installed in the BVM-D14H series video monitors,
the embedded audio CH1(L) and CH2(R) are output from
the connectors (pinjacks) on the connector panel. (The
channel setting is fixed.)
Note
After assigning input signals to each connector, carry out
the auto chroma adjustment for the monitor.
For the BVM-D14H series video monitors, use the AUTO
menu in the CONTROL PRESET ADJ menu.