Bkm-120D Sdi 4:2:2 Input Adaptor; Functions; Using The Input And Output Connectors - Sony BKM-120D Installation Manual

BKM-120D SDI 4:2:2 Input Adaptor

The BKM-120D SDI 4:2:2 Input Adaptor is a video
signal input adaptor for Sony video monitors. When
installed in an input option slot of the video monitor, it
provides video input and output connectors for the
monitor and a decoder for serial digital component
signals.
For the monitors in which the BKM-120D can be installed,
see the chart on page 1 (E).

Functions

Decoder for serial digital component
signals
The BKM-120D is equipped with a decoder for serial
digital component (525/625) signals.
Serial digital input and output signal
connectors
The BKM-120D is equipped with two input and two
output connectors for serial digital signals.
Active loop-through output (only terminals
with the mark)
Digital signals connected to the input connectors are
output.
Note
Digital signals are available only when the power of
the video monitor is ON.
Using the Input and Output
Connectors
For information about installing the BKM-120D in a video
monitor input option slot, see "Installing into Video
Monitors" on pages 15(E) and 16(E).
For installation in the LMD series monitor, refer to the
operating instructions of the monitor.
Configuration of input/output connectors
and signals that may be input
The configuration of the input and output connectors
and the signals that may be input are shown below.
DIGITAL
1
Serial digital component signals
IN
1
2
OUT
3
Serial digital component signals
IN
2
4
OUT
120D
Input of serial digital component signals
You can input serial digital signals to connectors 1
and 3. You can obtain active loop-through output of
those signals from connectors 2 and 4, respectively.
You need not attach the 75-ohm termination to
connectors 2 and 4.
Assigning input signals to connectors
Before inputting signals to the BKM-120D, you must
specify the type and format of the signal that will be
input to each connector.
For information about the signal assignment, refer to the
manual of your video monitor.
Signal assignment is not necessary for the LMD series
monitors.
Note
After assigning input signals to each connector, carry
out the auto chroma/phase adjustment.
For BVM-D9H/D14H series, carry out AUTO adjustment in
the CONTROL PRESET ADJ menu and for PVM-D20L/
D14L and PVM-20L/14L series, auto chroma/phase
adjustment.
3
(E)