ZappBug Heater User Manual page 12

Use & Operation
Thermometer Base Station Set Up
1. Remove the battery door on the back of the base station as, shown in
Figure 1 below.
2. Insert one AA battery. The LCD segments will light up for a few seconds to
verify that all segments are operating properly.
3. The thermometer base station will instantly display the ambient temperature.
The probe temperatures will update on the display within a few minutes after
you place batteries in the thermometer probe. See Thermometer Probe Set
Up on page 13.
1
Figure 1
1
2
Figure 2
©2014-2022 ZappBug. All rights reserved. Product specifi cations subject to change.
(continued)
Figure 1
1. Battery Compartment
2. Stand Mount
2
IMPORTANT: Insert batteries and set
up thermometer base station fi rst
Figure 2
1. Time
2. Ambient Room Temperature
3
3. Reception Icon
4. Probe Sensor Temperature
4