Description Of Main Parts - Nakayama PD5230 Quick Start Manual

EN

Description of main parts

Assembly instructions
Fig. 1
Gear case
Bolt x3
Engine
Clutch shoe
2. Throttle wire engine-to-gear case connection (Fig.2)
(1) Work open the connector case using a slotted screwdriver at point A, and
remove the case.
(2) Connect the throttle wire end on the engine side to its counterpart on the gear
case side.
(3) Reattach the connector case.
(4) Close the case securely.
Connector case
A
3
Gear case
Handle
Throttle lever
*
Throttle wire (gear case side)
Connector case
WWW.NAKAYAMATOOLS.COM
Drill
1. Gear case-to-engine (Fig. 1)
(1) Lay the engine on the ground
with the clutch shoe facing up-
wards. Screw the stud into the *
marked hole (1 spot only).
(2) Set the gear case on the engine
and loosely tighten the stud and
nut.
(3) Screw the other 3 bolts into the
Stud x1
remaining 3 holes, then tighten all 4
bolts securely and evenly.
Throttle wire (engine side)
Close in this direction
Grip
Engine
Connector case
Fig. 2