Step 5 Proceed Through The Screen Setup Menu - Hisense Laser Cinema User Manual

STEP 5 Proceed through the Screen Setup
Menu
PROJECTION MODE
If you need to flip the image over top-to-bottom and/or left-to-
right, select the Projection Mode.
AUTO GEOMETRIC CORRECTION
Before you use Auto Geometric Correction function, ensure that
the Laser Cinema and your mobile device are connected to the
same Wi-Fi network.
1. Adjust the Laser Cinema position by using the levelling feet
as needed, ensure the frame of the screen is located inside
the rectangular border.
2. Click Next to continue.
3. Scan the QR Code with your mobile device to begin
automatic geometric correction. When the app loads, the
Laser Cinema will display an alignment grid.
4. Click "+" on your mobile device to take a photo of the entire
screen and image. For best results, stand about 10 feet
Alignment grid
away from the screen and use landscape mode.
5. Click "upload" on your mobile device to complete the
automatic geometric correction.
NOTE:
• Please ensure you are standing in front of the screen to take
the photo, no deviation of more than 25° from the center of
the screen.
• Please ensure the whole Laser Cinema screen is fully visible
on the photo, including the Frame of the display.
• Please ensure all the 16 points of the grid on the screen are
all in focus when taking the photo.
• Please ensure the Laser Cinema screen image must take up
at least 60% of the overall photo size for correct geometric
correction.
MANUAL GEOMETRIC CORRECTION
Select points and move to fit the projected image into the
screen.
NOTE:
Manual Geometric Correction is only applicable in some models/
countries/regions.
15