7. Mounting Instructions
Owing to the relatively low operating temperatures, there are no minimum mounting height
requirements. The units may be placed at any practical height and may be mounted horizontally,
vertically or at any desired angle to blend in with the room's décor. Ceiling mounting is best for
efficiency as there is virtually no convection. Each panel size has a pair of mounting brackets
supplied when purchased. These brackets are not required for suspended ceiling installations – see page
9. When wall mounting it is recommended to use these brackets. Type "A" brackets are for the
IHP2424 panel, type "B" brackets are for the IHP4824, and type "C" brackets are for the IHP4141 panel.
Mounting Bracket Dimensions "A" IHP2424
♦
The ILO Heating Panel model 2424 is fitted with a safety latch mechanism that replaces the
need to use safety screws or security wire in wall and "on-ceiling" installations. Owing to the
design of the safety latch mechanism, the heaters can be removed from the mounting
brackets without the need of tools.
♦
The brackets may be mounted on the wall or ceiling.
♦
For the IHP2424, the primary fastener (hole) pattern is 13½" x 14" (343mm x 356mm).
Please observe the 13½" (343mm) dimension as it is critical for proper bracket insertion.
♦
The power supply cable may exit over the edges, or through the mounting bracket opening.
ILO North America
•
5410 West Roosevelt Road
•
Unit 205
•
60644
•
Chicago
•
Phone: +1(312) 508 8600
•
Website: http://www.ilo-international.com/
10