Mounting Instructions - iLO Si Series User And Installation Manual

7. Mounting Instructions

Owing to the relatively low operating temperatures, there are no minimum mounting height
requirements. The units may be placed at any practical height and may be mounted horizontally,
vertically or at any desired angle to blend in with the room's décor. Ceiling mounting is best for
efficiency as there is virtually no convection. Each panel size has a pair of mounting brackets
supplied when purchased. These brackets are not required for suspended ceiling installations – see page
9. When wall mounting it is recommended to use these brackets. Type "A" brackets are for the
SI-2424 panel, type "B" brackets are for the Si-2448, and type "C" brackets are for the Si-4141 panel.

The Si Series model Si-2424 is fitted with a safety latch mechanism that replaces the
need to use safety screws or security wire in wall and "on-ceiling" installations. Owing to the
design of the safety latch mechanism, the heaters can be removed from the mounting
brackets without the need of tools.

The brackets may be mounted on the wall or ceiling.

For the SI-2424, the primary fastener (hole) pattern is 13½" x 14" (343mm x 356mm).
Please observe the 13½" (343mm) dimension as it is critical for proper bracket insertion.

The power supply cable may exit over the edges, or through the mounting bracket opening.
Mounting Bracket Dimensions "A" Si-2424
10