Advertisement
6. Place gusset in corner where leg and frame meet.
Use a rubber mallet to tap the #10 self-drilling screws
into place.
7. Use a screw gun along with a 5/16" hex bit to finish
fastening the gussets to the leg and frame with the
#10 self-drilling screws.
Repeat for remaining gussets.
8. Adjust legs to desired height.
9. Remove nylon glide from leg by rotating counter
clockwise until glide is free.
wibenchmfg.com
ASSEMBLY
Specifications are subject to change. Product
images are for illustrative purposes only and may
differ from the actual product.
10. Place stem of optional footing into the hole on the
leg. Rotate clockwise until fully inserted into leg.
11. Tighten with a wrench.
Repeat for each caster or glide.
NOTE: Casters are not to be used as a leveling
device. Loctite on casters will cause some
resistance while tightening, please make sure
that casters are tightened all the way to prevent
possible damage to the stem of the caster.
507 E. Grant St. Thorp, WI 54771 • P - 800.242.2303
3
Advertisement
