Advertisement
The assembly of this table requires the
assistance of another person.
CAUTION! Some parts may have sharp
edges. Care must be taken when handling
various pieces to avoid injury. For your safety,
wear a pair of work gloves when assembling.
1a. If assembling a hardwood top that has a depth of
36" or less, it will be in one piece. Place the top face
down on a protected flat surface. Proceed to Step 3.
1b. If assembling a hardwood top that has a depth
greater than 36", top will be in 2 pieces (.5"
undersized on length). Place both top halves face
down on a protected flat surface. Align together the
dog bone holes on both tops.
2. Adjust tite joint fastener to the size of the field
joint opening and then place the fastener into each
opening. Using a 7/16" wrench, tighten each fastener
so that both tops are securely clamped together.
2
wibenchmfg.com
ASSEMBLY
Specifications are subject to change. Product
images are for illustrative purposes only and may
differ from the actual product.
NOTE: Hardware packs are included in
packaging. You may receive more hardware
than needed. Discard any extra hardware after
assembly.
3. Place LOBO frame tabs down on top of the top and
align tabs with pre-drilled pilot holes.
4. Using a #S2 square bit, secure the frame to top with
#10 x 3/4" square pan screws, one screw per tab.
5. Starting at one corner, place the 5/16" bolt that is
welded to leg through corner support brace of frame.
Place the 5/16" lock washer and 5/16" hex nut onto the
leg bolt and tighten with a 1/2" wrench.
Repeat for remaining legs.
507 E. Grant St. Thorp, WI 54771 • P - 800.242.2303
Advertisement
