Sony DSC-HX7 Service Manual page 10

1-6. ORNAMENTAL RING A OR BARRIER ASSY REPLACING METHOD
Removal
1 Turn on the power switch and extend the lens.
2 Detach the battery.
3 Pour a solvent such as alcohol from four places A to the tweezers or a needle shown below into a gap of Ornamental Ring A.
4 Remove while turning the Ornamental Ring A right and left.
Tweezers
A
Solvent
A
5 Remove Barrier Assy by disengaging four claws.
Claws
Barrier Assy
Claws
Installation
1 With four claws fitted in position, install the Barrier Assy.
Barrier
Lever
Claws
Hole
Claws
Barrier Assy
2 Peel off release papers of Barrier Tapes.
3 Install Ornamental Ring A and press it lightly.
Barrier Tapes
Barrier Tapes
DSC-HX7/HX7V_L2
1-7. CAM TUBE BLOCK REPLACING METHOD
Removal
1 Remove the four soldering, and disconnect the flexible board form the connector.
Ornamental Ring A
2 Remove the flexible board from the three tabs with peeling off the adhesive tapes.
3 Remove the screw, and remove the zoom motor.
Ornamental Ring A
1-7
Connector Solders
Adhesive Tapes
Flexible
Board
Tabs
Flexible
Adhesive Tapes
Board
Flexible
Board
Screw
Zoom Motor