Troubleshooting - Itek I60018CD Safety & Instruction Manual

Bluetooth:
1. Press the Power/Mode button on the
control panel or press the "MODE" button
on the remote repeatedly until 'bt' shows
on the LED screen. The LED will flash until
a device has been paired with speaker.
2. Pair a bluetooth enabled device with your
jukebox by selecting 'I60018CD' from the
listed devices on your smart phone/tablet.
When pairing is successful, the LED icon
'bt' will light up and you will hear a sound.
3. You can now play or skip songs using
your Bluetooth device, remote control or
jukebox control panel.
AUX-IN:
Requires a 3.5 mm cable (included).
1. Connect a 3.5 mm cable to the AUX-IN
1 jack. Connect the other end of the 3.5
mm cable to a smart-phone or other
audio source.
2. Press the Power/Mode button on the
control panel or press the "MODE" button
on the remote repeatedly to select AUX-IN
mode.
3. You can now play or skip songs using
your Bluetooth device.
Changing LED light:
1. Press the LED ON/OFF button on the
remote to turn the LED lights on. Press
this button again while the lights are
activated to turn them off.

TROUBLESHOOTING

The following checks will help correct some of
the most common issues with the unit. Check
that the power cord is firmly connected to the
unit before going through the check list below.
Should any problem persist after you have
made these checks, have the unit checked
by a qualified professional or contact our
Customer Support team.
Problem Possible Causes and
Solutions
The jukebox has Ensure that the adaptor has
no power. been properly connected.
Check that the jukebox has
been switched on at the mains
power supply.
The jukebox Check that the volume level
is not playing is set at an audible level and
sound. adjust accordingly.
Unable to pair Check if the device is
a Bluetooth compatible with the jukebox
device. and ensure the Bluetooth
function on your device is
switched on.
The jukebox may not be set
to the correct mode. Press
the source button to select
the Bluetooth function – when
the Bluetooth indicator light is
flashing, search for 'I60018CD'
on your device.
The remote The battery may be exhausted.
control is not Replace with a new battery.
working.
Make sure the remote is
pointed at the jukebox during
use.
The sound is The volume or bass level
distorted. may be too high. Reduce the
volume and/or bass levels to
increase sound clarity.
Note: The normal function of the product
may be disturbed by strong electro-magnetic
interference. Should this occur, simply reset
the product to resume normal operation. If the
issue persists, please move the product to a
location free from interference.
www.itek-products.co.uk
9