Troubleshooting - Itek I60020 Safety & Instruction Manual

Changing LED light
1. To turn the LED lights on , press the LED
ON/OFF button once on the remote. To
turn the lights off, press the LED ON/OFF
button again.
2. Long press the LED ON/OFF button on
the control panel to turn the LED lights on
and off.

TROUBLESHOOTING

The following checks will assist in the
correction of most problems which you may
encounter with your set. Before going through
the check list below, first check the following
points:
The power cord must be connected firmly.
Should any problem persist after you have
made these checks consult your nearest
dealer.
Problem Possible Causes and
Solutions
The jukebox has Ensure that the adaptor has
no power. been properly connected.
Check that the jukebox has
been switched on at the mains
power supply.
The jukebox Check that the volume level
is not playing is set at an audible level and
sound. adjust accordingly.
Unable to pair Check if the device is
a Bluetooth compatible with the jukebox
device. and ensure the Bluetooth
function on your device is
switched on.
The jukebox may not be set
to the correct mode. Press
the source button to select
the Bluetooth function – when
the Bluetooth indicator light is
flashing, search for 'I60020' on
your device.
The remote The battery may be exhausted.
control is not Replace with a new battery.
working.
Make sure the remote is
pointed at the jukebox during
use.
The sound is The volume or bass level
distorted. may be too high. Reduce the
volume and/or bass levels to
increase sound clarity.
Note: The normal function of the product
may be disturbed by strong Electro-Magnetic
Interference. If so, simply reset the product
to resume normal operation. If the issue
continues, please move the product to another
location.
www.itek-products.co.uk
9