Troubleshooting - Itek I60018CD Safety & Instruction Manual

station . The jukebox will stop
scanning once it picks up a radio
station and save.
5. Long press the Play/Pause button to
scan the radio station and save.
6. You can also press the Prog button
on the remote control to save a radio
station after scanning.
7. Press the Stop button play a
previously saved radio station.
Bluetooth:
1. Press the Power/Mode button on the
control panel or press the "MODE"
button on the remote repeatedly until
the "bt" shows on the LED screen.
The LED will flash until a device has
been paired with speaker.
2. Pair the bluetooth enable device with
your jukebox by selecting
"I60018CD" from the listed devices
on your smart phone/tablet. when
pairing successful ,the LED icon"bt"
will light up and will hear "DU" sound.
3. You can now play or skip songs
using your Bluetooth device , remote
control or jukebox control panel.
AUX-IN:
Requires a 3.5 mm cable (included).
1. Connect a 3.5 mm cable to the AUX-
in 1 jack. Connect the other end of
the 3.5 mm cable to a smart-phone
or other audio source.
2. Press the Power/Mode button on the
control panel or press the "MODE"
button on the remote repeatedly to
select AUXin mode.
3. You can now play or skip songs
using your Bluetooth device.
Changing LED light:
1. To turn the LED lights on , press
once LED ON/OFF button on the
remote , to turn the lights off , press
again the LED ON/OFF button .
2. Long press the LED ON/OFF button
on the control panel to turn the LED
lights on and off.

TROUBLESHOOTING

The following checks will assist in the
correction of most problems which you
may encounter with your set. Before
going through the check list below, first
check the following points:
The power cord must be connected
firmly. Should any problem persist after
you have made these checks consult
your nearest dealer.
Problem Possible Causes and
Solutions
Ensure that the adapter
The jukebox
has been properly
has no power.
connected.
Check that the jukebox has
been switched on at the
mains power supply.
The jukebox Check that the volume
is not level is set at an audible
playing level and adjust
sound. accordingly.
Check if the device is
Unable to
compatible with the
pair a
jukebox and ensure the
Bluetooth
Bluetooth function on your
device.
device is switched on.
The jukebox may not be
set to the correct mode.
Press the source button to
select the Bluetooth
function – when the
Bluetooth indicator light is
flashing, search for
'I60018CD' on your
device.
The remote The battery may be
control is not exhausted. Replace with a
working. new battery. Make sure the
remote is pointed at the
jukebox during use.
9