Before Your First Use; Using Your Appliance - Itek I60020 Safety & Instruction Manual

BEFORE YOUR FIRST USE:

1. Remove the product from the box.
2. Remove any packaging from the product.
3. Please retain all packaging until you have
checked and counted all the parts and the
contents against the parts list.
4. Your appliance is now ready for normal
use.
Dispose of the packaging in a responsible
manner.
USING THE REMOTE CONTROL TO
OPERATE THE UNIT:
Aim the remote control directly at the remote
control sensor (IR) on the front panel. Don't put
any objects between the remote control and
the system while operating the unit.
BATTERIES:
1. Slide out the battery
holder from the remote
control case. (Push tab
"A" towards the middle
first, see diagram).
2. Place one 3V CR2025
(Lithium) battery into the
battery holder, observing
the polar marking. If
the battery is placed
incorrectly, the remote control will not
work. Dispose of the old battery properly.
Do not leave it lying around where a you
child or pet could play with or swallow it.
3. The battery may explode or leak if it is
mistreated. Do not attempt to recharge it
or disassemble it. Do not dispose of the
old battery in a fire.
4. Insert the battery holder into the battery
compartment.
Note: Please remove all the batteries to
prevent damage or injury from battery leakage
if the unit will not be used for a long period of
time. Use only the specified size and type of
battery.

USING YOUR APPLIANCE

• Connect the included mains power
adaptor into the DC input socket on the
back of the jukebox and then plug the
adaptor into the main power supply
• Power on the unit, move the ON/OFF
button to the left side to turn the jukebox
on. To turn it off, push the switch to the
right.
• To turn the jukebox on, press the
Standby button on the control panel or
press the standby button on the remote
control.
• Short press the Source/LED ON OFF
button on the control panel or use the
Mode button on the remote control to
move between the FM,BT, Aux-in and
RCA modes.
• Adjust the volume using the Volume+
and Volume- buttons on the remote
control or by pressing the Volume+ and
Volume- buttons on the control panel.
• Switch the LED lights on or off by
pressing on the control panel , or by
pressing the LED ON/OFF button on the
remote control.
• Set the jukebox to standby on the
control panel or by pressing the Standby
button on the remote control.
www.itek-products.co.uk
7