Periodic Cleaning - Bunn ThermoFresh BT10 Use And Care Manual

Hide thumbs Also See for ThermoFresh BT10:

Use and care manual (12 pages)

Use and care manual (12 pages)

Table Of Contents

Table of Contents

(Recommended At Least Every Three Months.)

1) Slide an empty brew funnel into the brewer and center an empty carafe in

position on the brewer.

2) Pour one quart of white vinegar into the top of the brewer and close the lid.

Empty the carafe when liquid stops flowing from the funnel.

3) Allow the brewer to sit for two hours.

4) Unplug the brewer. Remove the brew funnel and sprayhead from the brewer

and set them aside.

5) To drain the brewer, continue to Step 6, OR to clear vinegar out of brewer

without draining, pour a carafe of fresh, cold water through the brewer. Place

carafe on brewer base, then close the lid to allow the water to run through the

brewer. After it has run through, empty carafe, and repeat the process

approximately 8 - 10 times. Proceed to Step 9.

6) Cool the brewer by pouring a full carafe of fresh, cold water into the top of the

brewer. Place carafe on brewer base, close lid. When flow from the brewer has

stopped, empty the carafe. Repeat this process, then set the carafe aside.

7) Grasp the back of the brewer and quickly turn it upside

down over a sink as shown. Most of the water in the tank will

flow from the sprayhead tube opening. Some water may

flow from the area around the top lid. Continue tipping the

brewer until the flow stops.

8) Replace the sprayhead and funnel after the water has been

drained. Pour a carafe of water into the top of the brewer.

Place the carafe on the brewer, close the lid. Repeat this

process with another carafe of water. Water will flow out

of the funnel after the second carafe. When flow from the

funnel has stopped, empty the carafe and pour an additional

carafe of water into the brewer. Place the carafe on the

brewer and close the lid.

9) Taste the water coming out of the brewer. Pour additional

carafes of fresh, cold water into the brewer as needed until

the water has no vinegar taste.

10) Plug in the brewer and allow the water in the tank to reach brewing temperature

before using. (approximately 15 minutes.)