Operation
DRY Operation
Remote controller
COOL operation starts when room
temp.is higher than temp.setting.
o
Temp.setting+2
C
Temp.setting
On reaching temp.setting +2
unit will run in mild DRY mode.
1. Unit start
Link with electronic power.
Press ON/OFF on the remote controller, unit starts.
The liquid crystal will display the working state of last
time (Except Timer, Sleep and Health airflow).
2.Select operation mode
Press MODE button. For each press, operation mode
changes as follows:
Remote controller:
Then Select DRY operation
3.Select temp.setting
Press TEMP. button
4.Fan speed selection
Press FAN button. For each press, fan speed changes as
follows:
Remote controller:
Air conditioner is running under displayed fan speed.
Ultra-low air flow
In DRY mode, when room temperature becomes
lower than temp.setting+2
at LOW speed regardless of FAN setting.
5.Unit stop
o
C
Press ON/OFF button, the unit stops.
Display panel
AUTO
Every time the button is pressed, temp.setting
o
increase 1
C,if kept depressed, it will increase
rapidly
Every time the button is pressed, temp.setting
o
decrease 1
C,if kept depressed, it will decrease
rapidly
Select a desired temperature.
LOW
COOL
DRY
FAN
MED
HI
o
C,unit will run intermittently
HEAT
AUTO