Table of Contents
Advertisement
1264C User Manual
Using This
Chapter
AC Mains
Power
Site
Considerations
Racal Instruments © 1998
CONFIGURING THE 1264C
This section includes basic procedures to install and configure the
1264C mainframe. Use this chapter to:
·
Review installation site considerations.
·
Install VXI modules or optional card guide covers and blanking
plates.
·
Connect the chassis/safety ground.
Installation
and
equipment is provided with the option.
When the standard 1264C is shipped, it is configured for 120 VAC
operation. Voltage selection switch S400 is set to the 115VAC
position.
Should it be necessary to replace the AC mains fuse (F400), refer
to Chapter 5: Removal and Replacement of the AC Mains Fuse.
Ordering Option 71 (P/N 407676) configures the
1264C for applications powered by 230 VAC power.
The voltage selection switch S400 is set to the
230VAC position, a 6.3A Slo-Blow fuse is installed
into
F400,
and
(P/N600858) replaces the domestic cord.
The 1264C Mainframe is designed to be used freestanding (bench
top) or in an instrument rack.
locations for the 1264C.
configuration
information
NOTE
an
international
Refer to Figure 1-5 for vent
Configuring The 1264C 2-1
Chapter 2
for
optional
power
cord
Advertisement
Table of Contents
