Specific Safety Rules For Dust Extractors; Residual Risks; Electrical Safety - DeWalt DCV586M Original Instructions Manual

Xr flex volt li-ion
Hide thumbs Also See for DCV586M:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 34
EnGLIsh

Specific Safety Rules for Dust Extractors

The appliance may only be used by persons who are familiar
with it, have been trained on how to use it safely and who
understand the resulting hazards.
When picking up dusts with an exposure limit value,
precautions must be taken to ensure adequate air exchange
in the room if the exhaust air from the appliance is released
into the room.
Operator should observe any safety regulations to the material
being handled.
Do not use to vacuum combustible explosive materials, such
as coal, grain, or other finely divided combustible material.
Do not use the appliance to pick up flammable or combustible
liquids, such as gasoline, or use in areas where flammable or
combustible liquids are present.
Do not use to vacuum hazardous, toxic or carcinogenic
materials, such as asbestos or pesticide, unless the vacuuming
of the material is specifically identified in this instruction
manual as an approved use.
Static shocks are possible in dry areas or when the relative
humidity of the air is low. This is only temporary and does not
affect the use of the dust extractor.
To avoid spontaneous combustion, empty the canister after
every use.
Some wood contains preservatives which can be toxic. Take
extra care to prevent inhalation and skin contact when
working with these materials. Request and follow any safety
information available from your material supplier.
Do not use vacuum as a step ladder.
Do not place heavy objects on dust extractor.

WARNING: To reduce the risk of fire, electric shock and
injury:
Do not pick up anything that is burning or smoking,
such as cigarettes, matches or hot ashes.
Do not use without filter in place.

Residual Risks

In spite of the application of the relevant safety regulations
and the implementation of safety devices, certain residual risks
cannot be avoided. These are:
Impairment of hearing.
Risk of personal injury due to flying particles.
Risk of burns due to accessories becoming hot
during operation.
Risk of personal injury due to prolonged use.

Electrical Safety

The electric motor has been designed for one voltage only.
Always check that the battery pack voltage corresponds to the
voltage on the rating plate. Also make sure that the voltage of
your charger corresponds to that of your mains.
Your D
WALT charger is double insulated in
e
accordance with EN60335; therefore no earth wire
is required.
34
If the supply cord is damaged, it must be replaced by a
specially prepared cord available through the D
service organisation.
Mains Plug Replacement
(U.K. & Ireland Only)
If a new mains plug needs to be fitted:
Safely dispose of the old plug.
Connect the brown lead to the live terminal in the plug.
Connect the blue lead to the neutral terminal.

WARNING: No connection is to be made to the
earth terminal.
Follow the fitting instructions supplied with good quality plugs.
Recommended fuse: 3 A.
Using an Extension Cable
An extension cord should not be used unless absolutely
necessary. Use an approved extension cable suitable for
the power input of your charger (see Technical Data). The
minimum conductor size is 1 mm
is 30 m.
When using a cable reel, always unwind the cable completely.
SAVE THESE INSTRUCTIONS
Chargers
D
WALT chargers require no adjustment and are designed to be
e
as easy as possible to operate.
Important Safety Instructions for All Battery
Chargers
SAVE THESE INSTRUCTIONS: This manual contains important
safety and operating instructions for compatible battery
chargers (refer to Technical Data).
Before using charger, read all instructions and cautionary
markings on charger, battery pack, and product using
battery pack.

WARNING: Shock hazard. Do not allow any liquid to get
inside charger. Electric shock may result.

WARNING: We recommend the use of a residual current
device with a residual current rating of 30mA or less.

CAUTION: Burn hazard. To reduce the risk of injury,
charge only D
WALT rechargeable batteries. Other types of
e
batteries may burst causing personal injury and damage.

CAUTION: Children should be supervised to ensure that
they do not play with the appliance.
NOTICE: Under certain conditions, with the charger
plugged into the power supply, the exposed charging
contacts inside the charger can be shorted by foreign
material. Foreign materials of a conductive nature such
as, but not limited to, steel wool, aluminum foil or any
buildup of metallic particles should be kept away from
charger cavities. Always unplug the charger from the
power supply when there is no battery pack in the cavity.
Unplug charger before attempting to clean
WALT
e
2
; the maximum length

Advertisement

Table of Contents
loading

Table of Contents