Cleaning And Care - Haier AC182ACABA Operation Manual

CLEANING AND CARE

CAUTION!
Cleaning the Air Filter
Open the Intake Grill
1. Pull out both sides and the center of the
Intake Grill.
About 30 mm
Arm
Intake Grill
2. Pull the Air Filters upward to remove
them.
Push the Air Filter handles away from the
Intake Grille in direction as illustrated, then
pull out Air Filters.
Handle
3. Clean the Air Filters.
Remove the dust from the Air Filters by
vacuum cleaner or washing them. After
washing, allow the Air Filters to dry
thoroughly in an area protected from sunlight.
Before cleaning the air conditioner ,be sure to turn it off and di
the Power Supply Cord.
Be sure the Intake Grill is installed securely.
When removing and replacing the air filters, be sure not to touch
exchanger, as personal injury may result.
Side Panel
Hook
Notch
Arm
Air Filter
Bracket
Base
4. Re-attach the Air Filters to the Intake Gri
The Filters fit onto the inside of the in
1
Grill. (figure 1)
2 The bottom edges of the Air Filters shoul
fit into the filter brackets. (figure 1)
The Air Filters should be pushed down so
3
that their top edges fit under the project
at the top of the Intake Grill. (figure 2
Air Filter
(Figure 1)
Filter bracket
5. Push in both sides and the center of the
Intake Grill.
Dust can be cleaned from the Air
either with a vacuum cleaner, or by washin
the filter in a solution of mild dete
warm water. If you wash the filter,
to allow it to dry thoroughly in a
place before reinstalling.
If dirt is allowed to accumulate on
Filter, air flow will be reduced, l
operating efficiency and increasing noise.
During periods of normal use, th
Filters should be cleaned every two weeks.
16
(Figure 2)