Listening To Station Presets; Naming Preset Stations - Pioneer HTP-500 Operating Instructions Manual

Using the tuner
Press PRESET / to select the station
3
preset you want.
You can also use the number buttons.
4 Press ENTER.
After pressing ENTER, the preset number stop
blinking and the system stores the station.

Listening to station presets

You will need to have some presets stored to do
this. See Saving station presets on page 42 if
you haven't done this already.
Press PRESET / to select the station
•
preset you want.
• You can also use the number buttons on the
remote control to recall the station preset.

Naming preset stations

For easier identification, you can name all of
your preset stations.
1 Choose the station preset you want to
name.
See Listening to station presets above for how
to do this.
2 Press TUNER EDIT twice.
The cursor at the first character position is
blinking on the display.
3 Input the name you want.
Choose a name up to eight characters long.
• Use the PRESET / buttons to select
character position.
• Use the TUNE / buttons to select
characters.
• The name is stored when ENTER is pressed.
Tip
• To erase a station name, follow steps 1 and
2, and press ENTER while the display is
blank. Press TUNER EDIT while the display
is blank, to keep the previous name.
• Once you have named a station preset,
press DISPLAY to show the name. When
you want to return to the frequency display,
press DISPLAY several times to show the
frequency.
06
43
En