Programming Functions - Telefunken TRC 200 Manual

Tips On Learning:
• Use fresh batteries for both remote controls.
• You can assign one remote control to each of the Mode keys.
• Place the remote controls with the infrared diodes on a table so that they point each other at a
distance between 15 and 50 mm.
• You can store up to 150 commands. When the memory is full, the red LED indicator will blink
for 3 seconds.
• Each programming of a key can take approx. 2 to 3 seconds.
• When Learning, you should normally not release the key being learned until the red LED
indicator goes out and then relights (2 to 3 seconds). However, some keys might be learned
multiple times if you do this. If this happens just "tap" the key you want to learn, rather than
press and hold it. For example, keys that you normally hold down for a while (like volume up or
down) will likely require a long press when learning. Keys that you normally give a quick press
(like the numbers, and channel up/down) will likely require a quick press when learning. If
after learning say the channel up key, you .find that it changes multiple channels when
pressed once, try relearning it with a short keypress.
• Always check that the key you wish to teach a code is free or does not correspond to an
important function.
• The following keys cannot be programmed with functions: LEARN, SETUP and all MODE keys.
• First have a try by programming any desired code and testing it then. Thereafter, delete all
codes and proceed with the proper programming.
• Do not use the learn function beneath an energy saving lamp.
If learning the first or second keys results in continuous errors then try the following:
1. Check the IR transmitters/sensors are correctly aligned between the two remotes (vertically
and horizontally).
2. Adjust the distance between the two remotes to be closer (e.g. 0.5 cm) or a further away
(e.g. 5 cm) from each other.
3. Try learning the original remote keys again.
4. If problems reoccur with the same key, check the original remote key being learned – does it
transmit? Does it operate the target device?
5. Clear all learned settings and try learning again.

Programming functions

1. Press and hold the Setup (19) key until the red LED indicator blinks and remains on. Release
the Setup key.
2. Press and release the Mode key (1) for the device you want to learn (TV, SAT, DVD,...). The red
LED indicator blinks once.
3. Press and release the Learn (21) key.
4. Now press and release the key on the universal remote control which will learn the function
(the red LED indicator blinks once and remains permanently light up).
5. Hold down the key of the original remote control you wish to copy until the red LED indicator
goes out and then relights (2 to 3 seconds). In case of problems, the red LED indicator will
blink for 3 seconds but will remain in learning Mode. Try again or try another key.
6. Repeat steps 4 to 5 until all desired functions are stored.
7. Press the Setup (19) key to .finish the programming.
Deleting commands under one mode key
To delete all codes referring to a device selection key, proceed as follows:
1. Press and hold the Setup (19) key until the red LED indicator blinks and remains on. Release
the Setup key.
2. Press and release the Mode key (1) for the device you want to delete the learned functions
(TV, SAT, DVD, ...). The red LED indicator blinks once.
3. Press and release the Learn (21) key twice.
4. Press once on the Setup key. The red LED indicator lamp goes out. All learned commands
entries under that mode are now cleared.
Deleting all commands under all modes
1. Press and hold the Setup (19) key until the red LED indicator blinks and remains on. Release
the Setup key.
2. Press and release the Learn (21) key twice.
3. Press on the Setup (19) key once. The red LED indicator goes out after several seconds. All
learned command entries are now cleared.
16