Huawei WiFi Q2 Pro Quick Start Manual page 13

If the page prompts "Unable to retrieve configuration from old router", ensure
that the power supply of the old router, and the Ethernet cable connecting
the WAN port of the old router to the LAN port of the new router are all well
connected, then restart the old router and touch TRY AGAIN.
If the problem persists, restore the router to its factory settings and follow the instructions
in this guide to reconnect the cables and re-configure the router.
6.
How do I restore a HUAWEI WiFi Q2 Pro to its factory settings?
Connect the router to the power supply and wait until the router completes the
startup process. Use a needle or pin to press the RESET button on the router
for more than two seconds until the indicator light goes out. Wait for the router to
complete the restart process. When the indicator turns red, this indicates that the
router has been restored to its factory settings.
If the configured router has been factory reset, you need to configure it again. Then
restore the other two routers to their factory settings so that they can automatically
connect to the configured router.
7. How do I connect an add-on Huawei router (with H/Hi button) to my HUAWEI
WiFi Q2 Pro's network?
Wired connection. Connect the WAN port of the add-on router (new or factory
reset) to the LAN port of the configured HUAWEI WiFi Q2 Pro using an
Ethernet cable.
Pairing through the H button. Step 1) Place the add-on router (new or factory
reset) within one meter of the configured HUAWEI WiFi Q2 Pro and connect it
to the power supply. 2) When the indicator on the HUAWEI WiFi Q2 Pro starts
to flash, press the H button on it. Wait until the indicator on the add-on router
shows it is connected to the network.
9