Compaq 1610 Reference Manual page 93

Device will not turn on
or the device does not
recognize the
memory.
Insufficient memory
error occurs during an
operation.
Memory expansion
module is installed
incorrectly or not
seated properly.
There is an unstable
connection between
the memory expansion
module and the device.
Memory has failed.
Device ran out of
program memory for
the application.
Reinstall the memory
expansion module.
Remove the memory
expansion module,
clean the edge
connector with a soft,
dry cloth, and reinstall
the module.
1. Remove the
memory expansion
module and turn on
the device.
If the same error
occurs, contact
Customer Support.
If the same error
does not occur,
clean the module
contacts, reinstall
the module, and
turn on the device.
2. If the error returns,
remove the module
and operate with
less memory until
the module is
replaced.
Close all open
applications and
delete files that are
not being used.
Adjust the amount
of available
program memory
(see "Adjusting
Memory" earlier in
this chapter).
Upgrade memory if
needed.
Continued