Optional Accessories - Makita DUH481 Instruction Manual

Removing or installing shear blade
CAUTION:
• Before removing or installing shear blade,
always be sure that the tool is switched off and
the battery cartridge is removed.
• When replacing the shear blade, always wear
gloves without removing blade cover so that
hands and face does not directly contact the
blade. Failure to do so may cause personal
injury.
NOTE:
• Do not wipe off grease from the gear and crank.
Failure to do so may cause damage to the tool.
Removing the shear blades
► Fig.16: 1. Screws 2. Under cover
Reverse the tool and loosen four screws and remove
the under cover.
NOTE:
• Be careful not to get your hands dirty as grease
is applied in the shear blade driving area.
► Fig.17: 1. Screws 2. Sponge 3. Washer
Loosen four screws and remove the blades. Remove
the washer and sponge from the shear blades and put
them aside. They are required for the later installation.
► Fig.18: 1. Gear 2. Sleeves 3. Washer 4. Groove
If the sleeves are still left in the holes of the gear,
remove the gear and push the sleeves out of it with a
screwdriver or the like.
NOTE: The washer underneath the gear may come
off by mistake when removing the gear. In this case,
return it to the original position as it was installed.
Installing the shear blade
► Fig.19: 1. Blade cover
Remove the blade cover from the old shear blades and
fit it onto the new ones to avoid contact with blades.
► Fig.20
Adjust the hole positions by turning the gear as illustrated.
► Fig.21: 1. Grease
► Fig.22: 1. Grease
Apply some grease provided with the new shear blades
as illustrated.
► Fig.23: 1. Blade 2. Sponge 3. Sleeves
Put the removed sponge in the same position as the
old one. Make sure that the sleeves provided with the
new shear blades are put on the pins of the blade.
Place the new shear blades on the tool so that the pins
fit in the holes of the gear. If the sleeves on the pins
come off mistakenly, put them into the holes of the gear
beforehand.
► Fig.24: 1. Screws 2. Washer
Install the blade and tighten the four screws and put the
removed washer in the same position as the old one.
► Fig.25: 1. Screws
Install the under cover on the tool and tighten the four
screws firmly.
Storage
The hook hole in the tool bottom is convenient for hang-
ing the tool from a nail or screw on the wall.
► Fig.26
Remove the battery cartridge and put the blade cover
on the shear blades so that the blades are not exposed.
Store the tool out of the reach of children carefully.
Store the tool in the place not exposed to water and
rain.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be per-
formed by Makita Authorized Service Centers, always
using Makita replacement parts.
OPTIONAL
ACCESSORIES
CAUTION:
• These accessories or attachments are recom-
mended for use with your Makita tool specified
in this manual. The use of any other accessories
or attachments might present a risk of injury to
persons. Only use accessory or attachment for
its stated purpose.
If you need any assistance for more details regard-
ing these accessories, ask your local Makita Service
Center.
• Blade cover
• Shear blade assembly
• Makita genuine battery and charger
• Chip receiver
NOTE:
• Some items in the list may be included in the
tool package as standard accessories. They
may differ from country to country.
11 ENGLISH