Removing The Speakers - HP LT3700 Service Manual

LT 4700 Inverter Removal
1 Remove the six screws that secure the inverter cover to the unit, and then lift the cover up and off the unit.
2 Disconnect the 15 cables from the connectors on the rear of the inverter board, and the remaining three cables from
the connectors on each side of the board.
Cable notes: 15 total cables on each board – 12 on back of board, 1 on each side. Pull the blue tabs straight out to
disconnect the cables.
3 Lift the inverter board up and off the unit.

Removing the Speakers

You have to remove the main bracket, but do not have to remove the power supply* or main board to remove the
speakers.
* For the 32-inch model, you must remove the power supply to remove the speaker.
To remove the speakers without removing the power supply or main board, remove the screws that secure the main
bracket, lift the bracket up to gain access to the speaker cable, and then disconnect and remove the cable.
Note: The left and right speakers are not the same.
HP High-Definition LCD TV Service Manual
63