Dometic CoolAir SP 950C Installation Manual page 6

Installation
6.1 Prescribed installation method
The compressor unit (fig. 1 1) is attached to the firm and straight rear panel of the cab or by means of a firm fasten-
ing frame.
I
NOTE
The connection line (fig.
the compressor unit.
The parking cooler with rear panel evaporator unit consists of the following components (fig. 1):
• CoolAir SP950C/SPX1200C compressor unit (1)
• CoolAir SP950I/SPX1200I rear panel evaporator unit (2) with connection line (3)
The parking cooler with roof evaporator unit consists of the following components (fig. 1):
• CoolAir SP950C/SPX1200C compressor unit (1)
• CoolAir SP950T/SPX1200T roof evaporator unit (4) with connection line (3)
6.2 Notes on installation
!
WARNING! Electrocution hazard
• Detach all connections to battery before starting installation of parking cooler.
• Make sure that all electrical components are electrically discharged before carrying
out work on them!
!
CAUTION! Health hazard
Improper installation of the parking cooler can result in irreparable damage to the
device and put the safety of the user at risk.
The manufacturer will not be held liable for claims if the parking cooler is not installed
according to this installation manual. That applies to malfunctions and the safety of the
air conditioning roof unit, in particular to injuries and damage to property.
A
NOTICE! Damage hazard
The manufacturer only assumes liability for parts included in the scope of delivery. The
validity of the warranty expires if the system is installed together with third-party parts.
I
NOTE
• The manufacturer strongly recommends the use of a vehicle-specific fastening
frame for an optimum installation procedure for the compressor unit on the rear
panel of the cab.
• After installing the unit, the specified parameters of the unit software must be
checked (refer to the installation instructions of the evaporator unit).
You should always read this installation manual all the way through before installing the parking cooler.
You should always observe the following tips and information when installing the parking cooler:
6
1
3) can only be installed after fitting the evaporator unit and
SP 950C, SPX 1200C
EN