Setting Up The Nshield Trusted Verification Device; Connecting The Metal Support Bracket; Software Installation; Connecting An Nshield Tvd - Entrust nShield Installation Manual

3. Setting up the nShield Trusted Verification
Device

3.1. Connecting the metal support bracket

Do the following:
1. Remove the nShield TVD and the metal stand from the packaging.
2. Slide the metal stand into the slots on either side of the TVD.
3. Route the USB cable through the groove in the base of the metal stand (if required).

3.2. Software installation

For software installation instructions, see the Remote Administration Client User Guide,
which is available on the installation media.

3.3. Connecting an nShield TVD

Do the following:
1. Connect the nShield TVD to your computer, using the USB cable.
2. If your operating system detects the nShield TVD automatically, allow it to finish.
nShield® Trusted Verification Device Installation Guide 5 of 9