HealTech Electronics GIpro DS Series Installation And Operation Manual

Download this manual

For use with the following DUCATI motorcycles (with and without ABS):

Hypermotard all variants

Monster all variants

Foreword

Congratulations on your purchase of a GIpro DS gear position indicator.

The GIpro from HealTech Electronics Ltd. is the most advanced gear position

indicator on the market today.

Unlike other gear indicators available for your bike, this product connects to the

self-diagnosis connector. It makes the installation very simple. The unit reads

data from the ECU, offering faster and more reliable readings than competing

products.

The display is auto learning, there are no buttons and no "programming wire".

Known limitation: Ducati motorcycles are not equipped with Gear Position

Sensor, therefore determining the gear in use is only possible when the engine is

running and the clutch is released.

GPDS-D02_Manual_en.pdf

http://www.gi-pro.net

pro DS-series

Installation and Operation Manual

Model GPDS-D02

(2010-2013),

(2009-2013)

[rev. 003]

Hyperstrada

(2010-2013),

- 1 -

Page 1 Foreword Congratulations on your purchase of a GIpro DS gear position indicator. The GIpro from HealTech Electronics Ltd. is the most advanced gear position indicator on the market today. Unlike other gear indicators available for your bike, this product connects to the self-diagnosis connector.
Page 2 Installation Find the 4-pole self-diagnosis connector under the seat. Detach the cover (cap) from the plug and connect the GIpro plug. Route the cable to the mounting location such a way that the separated GIpro Red wire goes near to the fusebox (located at the ride side of the engine frame) Pull off the fusebox from the metal clip to gain access to the wires at the back side.
Page 3 Reset If some gears are not indicated correctly, reset the unit and set it up again. If you change your gearing (install new front or rear sprocket), or you install a SpeedoHealer (or other speedometer calibrator), probably you’ll have to reset the GIpro and set it up again.

Gipro gpds-d02