Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Rise Ticker
Summary of Contents for Rise Ticker
- Page 1 Rise Ticker Hardware Install Guide www.RiseDisplay.com...
-
Page 2: Table Of Contents
Table of Contents Tools Required Technical Specifications ETL Certifications Wall Mount Ceiling Mount (option a) Ceiling Mount (option b) Ceiling Mount (option c) Connecting Sections Installing Corners Network Connectivity Troubleshooting Tools Required ● Cordless drill with phillips bit #1 & #2 ●... -
Page 3: Etl Certifications
ETL Certification support@risedisplay.com... -
Page 4: Wall Mount
Wall Mount 1. Connect the two metal brackets together with the two nut / bolt / washer sets. 2. Screw Wall Brackets (vertically) into wall studs (or use Anchors/drywall plugs) using a minimum of two-inch screws. 3. Attach the Sign Bracket onto the top frame via the caged nuts located in the top frame itself (there will be 4 caged nuts, 2 nuts per Sign Bracket.) support@risedisplay.com... -
Page 5: Ceiling Mount (Option A)
1. Attach the Triangular Sign Bracket onto the top frame via the caged nuts located in the top frame. Slide along the top of the ticker top to position the brackets then tighten.. (there will be 4 caged nuts, 2 nuts per Sign Bracket.) 2. -
Page 6: Ceiling Mount (Option B)
1. Attach the Sign Bracket onto the top frame via the caged nuts located in the top frame - slide along the top of the ticker top position the brackets. (there will be 4 caged nuts, 2 nuts per Sign Bracket.) -
Page 7: Ceiling Mount (Option C)
1. Loosely thread the ½” NPT female adapter (shown below) onto the ½” NPT support (male), do not fully tighten. NPT support not included. 2. Lift the ticker section and slide to align the cage nuts inside the channel on the top of the ticker with the adapter. -
Page 8: Connecting Sections
3. Tighten the adapter and use set screws to attach the adapter to the cage nuts in the top of the ticker. 4. Repeat for each of the support points for that section. Connecting Sections 1. Align all sign sections as diagrammed below. A1 is the master section with the controller and WIFI data receiver. - Page 9 4. Connect the power connection between sections A1 and A2. 5. Slide in a flat joining metal between sections A1 and A2, ensure the two sections are tightly together eliminating any seam, thread in and tighten 4 bolts on top and bottom of the cabinet to secure in place.
-
Page 10: Installing Corners
1. If you are using a wired connection, plug your Cat5 cable to the RJ45 port (see photo in step 7 on the previous page). If you ordered a twin ticker, there will be one RJ45 port on the right side and one on the left side. - Page 11 9090. More details check out the Rise Ticker App User Guide. 4. To update your content and control the scroll speed and brightness by downloading the Rise Ticker App from the Apple App Store or Google Play Store. support@risedisplay.com...
-
Page 12: Troubleshooting
● No content is appearing on your ticker - make sure the power cable is firmly connected. ○ If there is a white blinking LED in the top right of section A1, this means your ticker is in power save mode. Use the remote to turn off power save and resume scrolling content.
Need help?
Do you have a question about the Ticker and is the answer not in the manual?
Questions and answers