HP AG072A Installation Instructions page 2

Installing the HP 1U Rackmount
Keyboard with USB
NOTE: If the HP 1U Adjustable Toolless Rails do not
snap into place, ensure that they align with the holes
marked on the rack. The holes marked on the rack
must be in the same location for the front and rear of
the rack.
Align the HP 1U Adjustable Toolless Rails with the
1.
holes marked on the rack, and snap them into place.
Snap one end of the HP 1U Adjustable Toolless
a.
Rails into the Retma rails.
Extend the other half of the HP 1U Adjustable
b.
Toolless Rails to meet the appropriate rack depth,
and snap them into place.
Extend the inner slides until they lock into place.
2.
Align the unit with the extended inner slides, inserting
3.
the unit into the rack.
Slide the brace rail assembly in between the HP 1U
4.
Adjustable Toolless Rails from the rear of the rack.
Align the screw holes on the brace rail with the screw
5.
holes on the HP 1U Adjustable Toolless Rails.
Secure the brace rail to the HP 1U Adjustable Toolless
6.
Rails with two 6-32 screws.
Remove the two shipping screws from the rear of the
7.
1U rackmount keyboard and discard the screws.