Page of 3

HP AG072A Installation Instructions

1u rackmount keyboard with usb.
Hide thumbs
   

Advertisement

HP 1U Rackmount
Keyboard with USB
© Copyright 2006 Hewlett-Packard Development Company, L.P.
The information contained herein is subject to change without notice. The
only warranties for HP products and services are set forth in the express
warranty statements accompanying such products and services. Nothing
herein should be construed as constituting an additional warranty. HP shall
not be liable for technical or editorial errors or omissions contained herein.
January 2006 (First Edition)
Part Number 408569-001
About this device
The HP 1U Rackmount Keyboard with USB is a rack-
mountable 1U keyboard with touchpad.
NOTE: 1U equals 4.5 cm (1.8 in).
The 1U rackmount keyboard is mounted on rails with space
available to add a 1U KVM switch behind the unit. The 1U
rackmount keyboard can be used with all HP 5000 and
10000 Series racks.
The kit contains the following:
HP 1U Rackmount Keyboard with USB (1)
M6 screws (4)
6-32 screws (5)
HP 1U Adjustable Toolless Rails (2)
Cable management arm with brace rail (1)
Lock plates (2)
USB cables (2)
PS/2 cables (2)
USB cable labels (4)
This kit contains extra hardware for your convenience.
Rack warning
WARNING: To reduce the risk of personal
injury or damage to the equipment, be
sure that:
The leveling feet are extended to the
floor.
The full weight of the rack rests on the
leveling feet.
The stabilizing feet are attached to the
rack if it is a single-rack installation.
The racks are coupled together in
multiple-rack installations.
Only one component is extended at a
time. A rack may become unstable if
more than one component is extended
for any reason.

Advertisement

   Related Manuals for HP AG072A

   Summary of Contents for HP AG072A

  • Page 1: Installation Instructions, Kit Contents

    © Copyright 2006 Hewlett-Packard Development Company, L.P. The information contained herein is subject to change without notice. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty. HP shall not be liable for technical or editorial errors or omissions contained herein.

  • Page 2

    Installing the HP 1U Rackmount Keyboard with USB NOTE: If the HP 1U Adjustable Toolless Rails do not snap into place, ensure that they align with the holes marked on the rack. The holes marked on the rack must be in the same location for the front and rear of the rack.

  • Page 3

    Attach the cable management arm to the rear of the unit with two 6-32 screws. Connect and route the cables through the cable management arm and opening in the rail. Installation is complete.

This manual also for:

Ag072a - 1u rackmount keyboard

Comments to this Manuals

Symbols: 0
Latest comments: