Advertisement
2-8-2 Convergence Adjustment
<Cautions regarding Automatic Color Adjustment>
1. Aging the TV over 30 minutes is required.
2. Apply the NTSC input signal from the antenna or other external input source.
Before adjusting the Green, Red and Blue patterns, adjust the DY of the CRT to avoid
having a tilted center line.
3. Press Mute, 1, 8, and 3 (on the remote control) sequentially to enter Convergence Mode.
The Test Pattern is displayed.
If an OSD (On-Screen Display) appears during the process, press the
Convergence mode and then re-enter Convergence mode.
Samsung Electronics
This model employs the Automatic Color Adjustment function to prevent distortion
of the Convergence by the earth's magnetic field. For it to function properly, the
Convergence should be precisely adjusted.
The Screen Jig should be used for precise adjustment, so it does not escape the
sensor's detection area. Sensors are on the center of each of the 4 faces.
Adjustment should be precise, otherwise an Automatic Color Adjustment
error occurs.
Alignment and Adjustment
key to exit
2-25
Advertisement
