Table of Contents
Advertisement
AIR50-2230A Operation Manual
2.
Decelerator
3.
Adjacent to motor / reduce
4.
Inside the control cabinet
Warning
The parts (such as screws, etc.) removed during the replacement of the
◼
parts should be correctly loaded back to their original parts, and if the
parts are found to be insufficient or surplus, they should be reconfirmed
and installed correctly.
Warning
During the maintenance of the pneumatic system and hydraulic system, it
◼
is important to release the internal pressure to zero and operate again.
Warning
After replacing the parts, be sure to carry on the test operation according
◼
to the prescribed method. At this point, the operator must operate outside
the safety fence.
Warning
After the maintenance operation, the grease, debris and water sprinkled
◼
on the ground around the operator and inside the safety fence should be
thoroughly cleaned.
Warning
When replacing parts, dust and other foreign bodies should be prevented
◼
from entering the manipulator.
Warning
Operators who carry out maintenance and repair operations must receive
◼
the training of the company and pass the relevant assessment.
IX
General safety description
Advertisement
Table of Contents
