Midea ATOM MDV-V28WDHN1 Manual page 110

-I
Project name and location
DSP1
Parameters displayed on DSP2
content
0.-- Operating frequency
1.-- Operating mode
2.-- Operating fan speed level
3.-- Total capacity requirement of indoor units
4.-- Total capacity requirement for the modified ODU
5.--
T3 Condenser temperature(°C)
6.--
T4 Outdoor ambient
7.--
T5 discharge temperature(°C)
8.--
TF invert module Temperature(°C)
9.-- TL refrigerant cooling tube temperature (°C)
10.-- EXVA position
11.-- Actual current (A)
12.-- Inverter compressor current (A)
13.-- Actual voltage (V)
14.-- DC bus voltage (V)
15.-- Indoor heat exchanger pipe (T2/T2B) average temperature (°C)
16.-- Total number of IDUs
17.-- Number of Operating IDUs
18.-- Model
19.-- System address
20.-- Priority mode
21.-- Version of the program
22.-- Most recent error or protection code
23.-- Display "--"
Notes:
1. Operating mode:

0: standby; 2: cooling; 3: heating; 4: forced cooling.
2. The fan speed index is related to the fan speed in rpm and can take any integer value in the range 0 (0-off) to 8 (fastest).
3. Priority mode:

0: Automatic selection of priority mode; 1: cooling priority; 2: first ON priority; 3: heating only; 4: cooling only; 5: heating priority
System Commissioning Report – Sheet D
temperature(°C)
Atom B Series VRF 50/60Hz
System name
Remarks
Actual value = value displayed
Refer to Note 1
Refer to Note 2
Actual value = value displayed
Actual value = value displayed
Actual value = value displayed
Actual value = value displayed
Actual value = value displayed
Actual value = value displayed× 8
Actual value = value displayed
Actual value = value displayed
Actual value = value displayed
Actual value = value displayed
Actual value = value displayed
Actual value = value displayed
ODU address in the centralized control
system
Refer to Note 3
"nn" is displayed if no error or protection
events have occurred since start-up
Observed values
Cooling Heating
mode mode
109