Philips DVDR3305/02 Service Manual page 9

3. Firmware Upgrading / version verifi cation
A. Preparation to upgrade fi rmware:
1. Unzip the zip-archive fi le
2. Start the CD Burning software and create a new CD project
(data disc) with the following settings:
File system
Format
Recording mode
Note: Long fi le name is necessary for the preparation of the
upgrade disc
3. Place the content of the zip-archive into the root directory of
the new CD project.
4. Burn the data onto a blank CDR or CD-RW
B. Procedure to apply the fi rmware upgrade:
1. Power up the set and open tray.
2. Insert the prepared Upgrade CDROM and close the tray.
3. The TV connected to the set will display:
Software Upgrade Disc detected
Select OK to start or CANCEL to exit
4. Select OK or CANCEL with the <Right> or <Left> button and
press <OK> button to confi rm.
5. The TV connected to the set will display:
Upgrading Software, Please wait
Do not switch off the power
6. When the upgrading process is successful the tray will open
and the TV connected to the set will display:
System is successfully upgraded.
Remove disc from tray & reset system
7. Remove the Upgrade Disc and press <OK> button on
Remote control to confi rm
8. The TV screen goes blank and the Philips Logo screen
appear again after the tray door has closed.
Firmware Upgrading / version verifi cation
: Joliet
: MODE 1: CDROM
: SINGLE SESSION (TRACK-
AT-ONCE), FINALIZED CD
3139 785 3144x
C. How to Restore Factory setting (Default setting)
1. Power up the set and with no disc in the tray
2. Press <System Menu> <Right> and 4x <Down> buttons on
the Remote control to reach the Restore Factory setting
option.
3. Press <OK> button and the TV connected to the set will
display:
System will reset to the Factory settings.
Select OK to confi rm or CANCEL to exit.
4. Select OK or CANCEL with the <Right> or <Left> button and
press <OK> button to confi rm.
Note: All customers' settings will be lost.
D. How to read out the fi rmware version to confi rm
set has been upgraded.
1. Power up the set and with no disc in the tray
2. Press <0009> and <OK> buttons on the Remote control
3. The TV connected to the set will display:
DVDR3365_75_BT3_2, Drive: 43.02.11 Build:
FAE6206 Apr 21 2005, 18:49:43
where DVDR3365_75 = Type/version
BT3_2
43.02.11
3. EN 9
= Application (Backend) fi rmware
version
= Drive (Basic Engine) fi rmware
version