Wolf CSO24 Installation Information page 9

Installation Information
Installation With Trim
NOTES:
• Trim kits are an optional sales accessory and not required to install the convection steam oven.
• Depending on the trim kit you have purchased, trim panels may look slightly different than shown in the illustra-
tions. Not all parts provided with the trim kit will be used for installation with the convection steam oven.
• Before moving the oven, protect any finished flooring and cabinetry to avoid damage.
1. Move the convection steam oven into position near the installation opening. Remove and discard packing mate-
rials.
2. Position the trim panels as shown below. When properly oriented, the four mounting holes will be positioned
near the bottom of the four spacers.
3. Carefully place the oven in the opening. Resting the oven on the cabinet base support, slide the unit into the
opening until it is approximately 6" (152) from being fully installed. Guide the power cord through the opening of
the adjacent cabinet or base support as the oven is slid into position. Verify the power cord is not trapped
between the oven and cabinet wall.
4. Continue to slide the unit back into position until it is 1/2" (13) proud of the cabinet face frame. Open the oven
door and locate the four mounting holes on the oven side trim. Refer to the illustration below. Use a 1/16" drill bit
to drill pilot holes into the cabinet.
5. Locate the four mounting screws provided with the convection steam oven. Place the left trim panel behind the
oven side trim. Slide the left side of the oven back and install two of the mounting screws just far enough to hold
the trim in place. Repeat with the right trim panel.
6. To complete the installation, verify the trim panels align with oven trim and securely tighten all four mounting
screws.
MOUNTING
Trim Panel Orientation
#821162 - Revision A - January, 2012
SPACER
HOLE
Convection Steam Oven
Oven Installation With Trim
2-10
(CSO24)
OVEN MOUNTING HOLES