Cleaning; User Servicing Instructions; Lubrication; Storage - Shop-Vac AIR MOVER AM Series User Manual

8. Pull upwards
the three handle columns are
visible and you hear a click.
FIGURE 5
9. To completely lower handle, simply
press button and push downwards.
FIGURE 6.
FIGURE 6
10. To use your unit, place the unit in the area most
suitable for your application. Several factors need
to be considered; the unit must be placed close
enough to an AC outlet to be plugged in, there must
be a minimum clearance of two feet from either
side of the unit to allow for proper air flow, and the
unit should not be placed where it can become a
tripping or safety hazard.
11. Place unit in the proper operating position for your
application. Refer to the Operating Positions section
in this manual.
12. Plug unit into the wall.
13. Turn unit on and select air speed by turning the
switch, located near the top handle, counter clock-
wise.
14. When your drying job is completed, turn the unit off
and follow the directions for Storage in this manual.
OPERATING
POSITIONS
15. The air mover may be set in one of two operating
positions. Pick the position best suited for your
application.
16. Use the down position
FIGURE 7
FIGURE 5
FIGURE 7
for applications
such as; drying wet floors,
shampooed carpets, etc. To use
this position simply place unit
on its base.
until
FIGURE 8

CLEANING

WARNING!
TO REDUCE THE RISK OF INJURY FROM THE
AIR MOVER ACCIDENTALLY STARTING, UNPLUG
POWER CORD BEFORE CLEANING.
18. The outside of the unit may be cleaned with a damp
cloth to remove any dust or residue.
USER SERVICING
INSTRUCTIONS
WARNING!
BE SURE TO DISCONNECT POWER SUPPLY
BEFORE ATTEMPTING TO SERVICE OR REMOVE
ANY COMPONENTS.
19. Do not attempt to service your air mover beyond
that described in the user manual. For all other ser-
vicing, follow instructions under Warranty Section.
20. No lubrication is necessary as the motor is equipped
with lifetime lubricated bearings.
21. Before storing your air mover it should be cleaned.
For cleaning instructions, refer to the Cleaning sec-
tion in this manual.
17. Use the up position for applica-
tions such as; drying paint on
the ceiling. To use this position,
make sure the transport handle
is secured at the lowest height.
Lay the unit on the back side with
the front grill pointing towards
the ceiling.
FIGURE 8.

LUBRICATION

STORAGE

PAGE 5