Cleaning; User Servicing Instructions; Lubrication; Storage - Shop-Vac AM Series User Manual

3. Use the up position for applications such as; drying paint on the ceiling. To use this
position, lay the unit on the back side with the front grill pointing towards the ceiling.
WARNING
ACCIDENTALLY STARTING, UNPLUG POWER CORD BEFORE CLEANING.
The outside of the unit may be cleaned with a damp cloth to remove any dust or residue.

USER SERVICING INSTRUCTIONS

WARNING
TO SERVICE OR REMOVE ANY COMPONENTS.
Do not attempt to service your air mover beyond that described in the user manual. For all other servicing,
follow instructions under Warranty Section.
No lubrication is necessary as the motor is equipped with lifetime lubricated bearings.
1. before storing your air mover it should be cleaned. For cleaning instructions, refer to the Cleaning section
in this manual.
2. Wrap the power cord around the carry handle on the top of the unit to keep it
untangled.
3. If you have more then one unit to store they may be stored by stacking them. Stack
the units by placing them on their sides making sure the indented side is facing
down. Do not stack the units more then 3 high. Never operate the unit while it is on
its side or stacked. THE AIR MOVER SHOULD BE STORED INDOORS.
PROBLEM
Will not start
OPERATION (CONT'D)

CLEANING

–
TO REDUCE THE RISK OF INJURY FROM THE AIR MOVER
–
BE SURE TO DISCONNECT POWER SUPPLY BEFORE ATTEMPTING

LUBRICATION

STORAGE

TROUBLESHOOTING

POSSIBLE CAUSES
1. Power cord not plugged into
outlet
2. No Power at the outlet
3. Defective switch or motor
SOLUTION
1. Plug cord into outlet
2. Plug cord into another outlet
3. Contact Shop-Vac
service
customer
®
PAGE 5